Conversations
Studio Display network passthrough cuts 2.5G download to about 600Mbps
A user with symmetric 2.5G broadband found downloads were only about 600Mbps while uploads remained around 2.4Gbps. Troubleshooting confirmed the problem came from the single-cable setup of plugging a UGREEN 2.5G USB-C network adapter into the 2026 Studio Display XDR: a direct connection to the Mac reached over 2.2Gbps, while installing the Realtek driver and enabling flow control each improved speed, but the material cuts off at the side effects of flow control.
The user’s network is a symmetric 2.5G line. During one speed test, downloads were only about 600Mbps, while uploads were still 2.4Gbps. The ISP checked the line and found no abnormality, and the user obtained similar results testing with a work laptop. They later realized the problem began around the time they migrated all connections to the 2026 Studio Display XDR to enable switching laptops with a single cable.
Their equipment includes a MacBook Pro M3 Pro, a 2026 Studio Display XDR, a UGREEN USB-C to 2.5G Ethernet adapter plugged into the display, and a UniFi Dream Router 7. During downloads, the wired network through the display had a 10% failure rate when pinging another wired computer, while Wi-Fi was 0%; there were no dropped-frame errors in macOS logs, leading the user to conclude that frames might have been discarded by the adapter before the computer became aware of them.
After plugging the same adapter directly into the Mac, iperf3 measured about 2.3Gbps, and fast.com download and upload speeds were about 2.2Gbps and 2.3Gbps respectively, showing that the cable, router, and adapter itself were functional; once reconnected through the display, downloads fell back to about 600Mbps.
During further troubleshooting, the user found the adapter used a Realtek RTL8156B and was originally bound to Apple’s generic USB networking driver on macOS. After installing Realtek’s official driver, downloads nearly doubled to about 1.1Gbps, but were still far below 2.5G. They then enabled flow control in the UniFi console, allowing pause frames to be sent when the receiver could not keep up and having the sender buffer data; downloads improved to about 2Gbps, while uploads remained at full speed. The material cuts off as the author explains why they do not want flow control always enabled and its potential side effects.